Pioneer TS-D65C D Series 6-1/2" component speaker system
- Free Shipping
- component speaker system includes two woofers and two tweeters
- 6-1/2" injection-molded polypropylene woofer cone interlaced with aramid fibers
- 1" polyester soft dome tweeter with inline crossover
- handles up to 90 watts RMS (270 watts peak power)
- frequency range: 32-49,000 Hz
- sensitivity: 84 dB
- woofer top-mount depth: 2-5/8"
- impedance: 4 ohms
- warranty: 1 year
Features and Specs
|Speaker Size||6 1/2|
|Tweeter Design||1" Dome|
|Woofer Composition||IMPP with Aramid Fiber|
|Parts Warranty||1 Year|
|Labor Warranty||1 Year|
|Sensitivity (1W at 1 meter)||84|
|Sensitivity at 2.83 volts||N/A|
|Frequency Response||32 - 49k Hz|
|Minimum RMS Wattage||---|
|Maximum RMS Wattage||90|
|Peak Power Handling (Watts)||270|
|Top-mount Depth (Inches)||2 5/8|
|Bottom-mount Depth (Inches)||N/A|
|Cutout Diameter or Length (inches)||5 1/2|
Woofers: Each woofer uses an aramid fiber interlaced injection-molded polypropylene (IMPP) cone. This process of cone molding assures a uniform thickness and the addition of aramid fibers adds rigidity to the cones.
Size Classification Note: Some manufacturers, including Pioneer, call this size woofer a 6-1/2". Because it requires a larger cutout than a standard 6-1/2" speaker, Crutchfield has traditionally referred to this size as a 6-3/4". Please refer to the Crutchfield Vehicle Selector to confirm fit in your vehicle.
Tweeter Mounting: The tweeters can be flush mounted or mounted behind a factory grille using the included housings. Once installed in either housing the tweeters will pivot, so they can be angled to optimize imaging.
Tweeter Mounting Dimensions:
|Factory Mount||Flush Mount|
Crossovers: The high pass crossovers are integrated into the included speaker wire and the low pass crossovers are integrated into the woofer baskets. Both are 6 dB/octave and the crossover point is 3 kHz. The two lengths of speaker wire each connect to both a woofer and tweeter. Quick slides connect to the woofer, a 40" output leg with integrated crossover (approximately 1/2" diameter x 3/4" long) connects to the terminals attached to the tweeter, and an 11" input leg connects to the source.