Pioneer TS-D69C D Series 6"x9" component speaker system
- Free Shipping
- component speaker system includes two woofers and two tweeters
- 6"x9" injection-molded polypropylene woofer cone interlaced with aramid fibers
- 1" polyester soft dome tweeter with inline crossover
- handles up to 110 watts RMS (330 watts peak power)
- frequency range: 33-49,000 Hz
- sensitivity: 86 dB
- woofer top-mount depth: 2-15/16"
- impedance: 4 ohms
- warranty: 1 year
Features and Specs
|Tweeter Design||1" Dome|
|Woofer Composition||IMPP with Aramid Fiber|
|Parts Warranty||1 Year|
|Labor Warranty||1 Year|
|Sensitivity (1W at 1 meter)||86|
|Sensitivity at 2.83 volts||N/A|
|Frequency Response||33 - 49k Hz|
|Minimum RMS Wattage||---|
|Maximum RMS Wattage||330|
|Peak Power Handling (Watts)||110|
|Top-mount Depth (Inches)||2 15/16|
|Bottom-mount Depth (Inches)||3 3/8|
|Cutout Diameter or Length (inches)||0|
Woofers: Each woofer uses an aramid fiber interlaced injection-molded polypropylene (IMPP) cone. This process of cone molding assures a uniform thickness and the addition of aramid fibers adds rigidity to the cones.
Tweeter Mounting: The tweeters can be flush mounted or mounted behind a factory grille using the included housings. Once installed in either housing the tweeters will pivot, so they can be angled to optimize imaging.
Tweeter Mounting Dimensions:
|Factory Mount||Flush Mount|
Crossovers: The high pass crossovers are integrated into the included speaker wire and the low pass crossovers are integrated into the woofer baskets. Both are 6 dB/octave and the crossover point is 3 kHz. The two lengths of speaker wire each connect to both a woofer and tweeter. Quick slides connect to the woofer, a 40" output leg with integrated crossover (approximately 1/2" diameter x 3/4" long) connects to the terminals attached to the tweeter, and an 11" input leg connects to the source.